Les routeurs Cisco et IOS. Configuration de la route par défaut. En mode configuration ip route adrIPReseau masque adrIPGateway route statique. Le pare-feu VPN sans fil N Cisco RVW comprend: la prise en charge du routage statique, versions RIP (Routing Information Protocol) 1 et 2 et du routage. CONFIGURATIONS LINUX Vérifiez que ROUTEUR CISCO IOS: a , ROUTEUR QUAGGA A interface.
| Author: | Milkree Yonris |
| Country: | French Guiana |
| Language: | English (Spanish) |
| Genre: | Personal Growth |
| Published (Last): | 5 May 2016 |
| Pages: | 202 |
| PDF File Size: | 9.18 Mb |
| ePub File Size: | 1.21 Mb |
| ISBN: | 570-2-66457-539-7 |
| Downloads: | 95098 |
| Price: | Free* [*Free Regsitration Required] |
| Uploader: | Akile |
Well, 1 is the foutage distance AD and 0 is the metric of that static route. This Article Applies to: Business Wireless Takes your enterprise Wi-Fi to new levels.
Input destination network, subnet mask, default gateway, select status and save it. Thank you We appreciate your feedback.
According to scenario 1 and scenario 2: The commands to add a static route are as follows: All articles with unsourced statements Articles with unsourced statements from December Please turn it on for the best experience. User Application Requirement Updated Static Route Overview Static Route Overview If you decide that you want specific Layer 3 traffic to take a certain route without participating in IP routing protocols, you Static routing is a form of routing that occurs when a router uses a manually-configured routing entry, rather than information from a dynamic routing traffic.
In this tutorial we will connect two routers via static route with GNS3.
How to configure Static Routing on wireless routers?
Static route and Dynamic route Static route tells the device exactly where to send traffic, no matter what. Please refer to following introduction to input parameter. IGRP has an administrative distance of Click configuartion IP or IPv6 tab to specify the Unicast —Install the route in the unicast route table.
Choose this option if you want either unicast or multicast traffic to use the route. Type the username and password in the login page.
Configure a Static Route
As per scenario 2, for single IP address. The following is typed at a terminal: The administrative distance is a measure of trustworthiness where lower numbers are considered to be more staatique than higher numbers.
Configure a Static Route. TP-Link takes your privacy seriously.
How to configure Static Routing on wireless routers? | TP-Link
Therefore, if you want PC to visit servers in intranet, you have to set up a static route on router2 helps your packet route to router1. And RIP has an administrative distance of R0 show ip route.
Static route tells the device exactly where to send traffic, no matter what. These parameters are straightforward and easy to understand. Perform the following task to configure Static Routes or a default route for a virtual router on the firewall.
As per scenario 1, for net segment.
In 2 nd bar, type the IP subnet mask for this destination. Static routing and dynamic routing are not mutually exclusive. IP subnet mask for this net segment is Subscription TP-Link takes your privacy seriously.
How to configure Static Routing on wireless routers?